Tosibox Lock 500 User Manual

TABLE OF CONTENTS
14
4. INSTRUCTIONS FOR TOSIBOX
®
KEY AND LOCK SETUP
1.
2.
3.
4.
5.
1. Make sure the Lock is powered before
proceeding to matching the Key with the Lock.
Insert the Key into the USB port of the Lock.
When the LED on the Key turns off, the matching
is complete (approximately 10 seconds)..
Remove the Key from the Lock. You can also
match additional Locks to the same Key.
2 - 3. Connect the Lock to your network according to
your use case. Remember to make sure that the
Lock has a working internet connection.
4. Connect the Key to your computer and install the
Key software. Follow the section ”Deploying the
Key”.
5. The TOSIBOX
®
connection is now ready to be
used to control and monitor remote devices.
THE FIRST DEPLOYMENT

Tosibox Lock 500 Specifications

General

Brand	Tosibox
Model	Lock 500
Category	IP Access Controllers
Language	English