Tosibox Lock 500 User Manual

TABLE OF CONTENTS
18
Choose “Settings” > “Software update”. If there is a software 3.
update available for the Lock, you can start the update by clicking
the “Start software update” button.
Wait until the update has been downloaded and installed. Do not 4.
interrupt the power of the Lock during the software update
process. The update is complete when the software gives a notice
“Software updated successfully”.
Automatic software updates are activated as a default setting.
You can select the time when the automatic update of the released
software is allowed. You can deactivate the automatic software
update from the Lock user interface.
Choose “Settings” > “Software update” > uncheck the box “Auto-
update enabled”.
5.4 USB MODEM SETTINGS FOR THE LOCK
You can connect the Lock to the Internet with a USB Modem. For
information on supported modems go to:
http://www.tosibox.com/support.
Log in as admin user, select “Network” > “USB Modem”.1.
Either use the Automatic APN setting or fill in the APN and if 2.
necessary the PIN field according to the SIM card settings. For APN
settings information, please contact your mobile operator.
Confirm the selection > Save.3.
Connect a Tosibox supported USB Modem to the USB port of the 4.
Lock
5.5 INTERNAL MODEM SETTINGS FOR THE LOCK
(LOCK 500I ONLY)
You can connect the Lock to the Internet with an internal Modem.
Before inserting or removing the SIM card(s), disconnect the Lock
power supply.
Log in as admin user, select “Network” > “Internal Modem”1.
Either use the Automatic APN setting or fill in the APN and if 2.
necessary the PIN field according to the SIM card settings. For APN
settings information, please contact your mobile operator.
Confirm the selection > Save.3.
5.6 WLAN SETTINGS FOR THE LOCK
(LOCK 100 AND LOCK 500 ONLY)
On Lock 100 and Lock 500 you can configure the WLAN as Client
(providing Internet access for the Lock) or as Access Point
(providing access to Lock LAN and Internet for wireless devices).
For detailed set-up instructions go to
http://www.tosibox.com/support.
5.7 KEY CONNECTION SETTINGS FOR THE LOCK
You can change the Key connection type from Layer 3 -routed
(default) to Layer 2 -bridged (“Connection type” > “Layer 2
-bridged”).
On Layer 2 connections you can allow connections from Lock to
Key. Log into the Lock as admin, select “Settings” > “Keys and
Locks” > remove selection “Deny access towards client”

Tosibox Lock 500 Specifications

General

Brand	Tosibox
Model	Lock 500
Category	IP Access Controllers
Language	English