tousek / EN_PULL-T8-T10-T15-M-S_02 / 25. 03. 2020 - 11 -
Warning
• Before taking o the control cover, the
mains switch must be turned o!
• If the control is power supplied, its inner part is under tension.
• In order to avoid electrical strokes, the safety regulations have to be kept.
• The device may only be connected by trained professionals.
• The product is not suitable for installation in explosion-hazardous areas.
• An all-pole disconnecting mains switch with a contact opening gap of min. 3 mm has to be foreseen. The gate
facility has to be secured according to the valid safety regulations!
• IMPORTANT: The control lines (buttons, radio, photocells, etc.) have to be laid separately from the 230V lines
(supply line, motors, signal lamp).
To Next Page
Loading...
