132
5. If you still cannot access the internet, please restore your modem router to its
factory default settings and reconfigure your modem router by following the
instructions in Use Quick Setup Wizard.
6. Please contact our Technical Support if the problem still exists.
T5. How to configure MAC Clone?
You can manually change the MAC address of the modem router. It is helpful when your
internet access account provided by your ISP is bound to one specific MAC address,
in other words, your ISP just permits only one computer with the authenticated MAC
address to access the internet. In this case, you can use MAC Clone to allow more
computers to access the internet via the same account.
1. Visit http://tplinkmodem.net, and log in with password you set for the modem router.
2. Go to Advanced > Network > Internet page. Click the Add icon, and scroll down to
get the MAC Clone section.
• If you are using the computer with the authenticated MAC address to access
the modem router, please select Use Current Computer MAC Address.
• If you know the authenticated MAC address, please select Use Custom MAC
Address and then enter the address.
3. Click OK to make the settings effective.
T6. How to use the WDS Bridging function to extend my wireless network?
My house covers a large area. The wireless network coverage of the router I’m using (the
root router) is limited. I want to use an extended router to extend the wireless network of
the primary router. Follow the steps to configure the modem router.
1. Visit http://tplinkmodem.net, and log in with account you set for the modem router.
2. Configure the LAN IP address of the modem router in the same subnet as the root
router. For example, the IP address of the root router is 192.168.1.1, the IP address
of the extended router should be from 192.168.1.2 to 192.168.1.254.).
To Next Page
Loading...
