Configuration Guide 448
Configuring QoS Bandwidth Control Configuration
3
Bandwidth Control Configuration
To implement bandwidth control, you can:
Limit the ingress/egress traffic rate on each port by configuring the Rate Limit function;
Limit the broadcast, multicast and UL frame forwarding rate on each port to avoid
network broadcast storm by configuring the Storm Control function.
3.1 Using the GUI
3.1.1 Configuring Rate Limit
Choose the menu QoS > Bandwidth Control > Rate Limit to load the following page.
Figure 3-1 Rate Limit
Follow these steps to configure the Rate Limit function:
1) Configure the upper rate limit for the port to receive and send packets.
Ingress Rate (1-
1000000Kbps)
Configure the upper rate limit for receiving packets on the port. The valid values
are from 1 to 1000000 Kbps.
To Next Page
Loading...
