Configuring LLDP Configuration Example
Configuration Guide
665
Switch_A(config)#interface gigabitEthernet 1/0/2
Switch_A(config-if)#switchport voice vlan mode manual
Switch_A(config-if)#switchport general allowed vlan 10 tagged
Switch_A(config-if)#exit
4) Enable LLDP globally.
Switch_A(config)#lldp
5) Configure the fast start count of LLDP-MED. The default is 4.
Switch_A(config)# lldp med-fast-count 4
6) Enable the LLDP-MED on port Gi1/0/1.
Switch_A(config)#interface gigabitEthernet 1/0/1
Switch_A(config-if)#lldp med-status
7) Configure the LLDP-MED TLVs included in the outgoing LLDP packets.
Switch_A(config-if)#lldp med-tlv-select all
8) Configure the detailed address of the IP phone.
Switch_A(config-if)#lldp med-location civic-address language English lci-city
Vancouver street X east hastings street postal-zipcode V6A 1P9
Verify the Configurations
View global LLDP-MED settings:
Switch_A#show lldp
LLDP Status: Enabled
LLDP Forward Message: Disabled
Tx Interval: 30 seconds
TTL Multiplier: 4
Tx Delay: 2 seconds
Initialization Delay: 2 seconds
Trap Notification Interval: 5 seconds
Fast-packet Count: 3
LLDP-MED Fast Start Repeat Count: 4
View LLDP-MED settings on each port:
Switch_A#show lldp interface gigabitEthernet 1/0/1
LLDP interface config:
To Next Page
Loading...
