TP-Link TD-W8901G User Guide

TD-W8901G 54M Wireless ADSL2+ Router User Guide
22
¾ DHCP Relay: Select Relay, then you will see the next screen (shown in Figure 4-11), and the
Router will work as a DHCP Relay. A DHCP relay is a computer that forwards DHCP data
between
computers that request IP addresses and the DHCP server that assigns the
addresses. Each of the device's interfaces can be configured as a DHCP relay. If it is enabled,
the DHCP requests from local PCs will forward to the DHCP server runs on WAN side. To
have this function working properly, please run on router mode only, disable the DHCP server
on the LAN port, and make sure the routing table has the correct routing entry.
Figure 4-11
• DHCP Server IP for Relay Agent: Enter the DHCP server IP Address runs on WAN
side.
)
Note:
If you select Disabled, the DHCP function will not take effect.
4.3.3 Wireless
Choose “Interface Setup→Wireless” menu, and you will see the Wireless screen (shown in
Figure 4-12 ). Please configure the parameters for wireless according to the descriptions below.

TP-Link TD-W8901G Specifications

General

Wireless Speed	Up to 54Mbps
Frequency Band	2.4GHz
ADSL Speed	Downstream: up to 24Mbps, Upstream: up to 3.5Mbps
Wireless Standards	IEEE 802.11g, IEEE 802.11b
ADSL Standards	ITU-T G.992.1 (G.dmt), ITU-T G.992.2 (G.lite), ITU-T G.994.1 (G.hs)
Ports	4 x 10/100Mbps LAN, 1 x RJ-11 ADSL
Antenna	1 x Fixed
Security	64/128-bit WEP, WPA
Protocols	TCP/IP, PPPoE, PPPoA, DHCP
Weight	0.6 lbs (273g)