TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide
Y
ou can select corresponding WAN Interface from the drop-down list and click Clone button to
clone your current PC MAC.
Click Restore Default button to restore the WAN Interface’s default MAC Address.
Note:
Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not
be the same with each other.
4.4.4 LAN
Choose “Advanced Setup”“LAN”, it includes two menus: IPv4 LAN Config and IPv6 LAN
Config. The detailed descriptions are provided below.
4.4.4.1 IPv4 LAN Config
Choose “Ad
vanced Setup”“LAN” “IPv4 LAN Config”, and you will see the LAN screen
(shown in Figure 4-21), the section allows you to configure the
router’s LAN ports settings.
Figure 4-21
IP Address: You can configure the router’s IP Address and Subnet Mask for LAN Interface.
IP Address: Enter the router’s local IP Address, then you can access to the Web-based
Utility via the IP Address, the default value is 192.168.1.1.
29
To Next Page
Loading...
