TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide
End interface ID: Enter a value for the DHCPv6 server to end with when issuing IPv6
addresses.
Leased Time (hour): The Leased Time is the amount of time in which a network user will
be allowed to connect to the modem router with their current dynamic IPv6 address.
Enter the amount of time, in hours, then the user will be “leased” this dynamic IPv6
address. After the dynamic IPv6 address has expired, the user will be automatically
assigned a new dynamic IPv6 address. The default is 24 hours.
For RADVD:
1) If Randomly Generate is selected, it doesn’t need to be configured.
2) If Statically Configure is selected, please complete the following parameters.
Prefix: Enter a value for the site prefix.
Click Save/Apply to make the configuration take effect.
4.4.5 NAT
NAT (Network Address Translation) allows you to share one WAN (Wide Area Network) IP
address for multiple computers on your LAN (Local Area Network).
Note:
When you select PPPoA or PPPoE for the WAN Setup, or when you select Enable NAT for the
type of IPoA and IPoE connection (4.4.2 WAN Service)
, you will see the NAT menu in the
Web-based Utility (shown in Figure 4-24).
Figure 4-24
Choose “Advanced Setup”“NAT”, there are three submenus under the main menu: Virtual
Servers, Port Triggering, DMZ Host and ALG. Click any of them, and you will be able to
configure the corresponding function.
32
To Next Page
Loading...
