TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-63
Mechanism: DS-Lite, this type is used in the situation that your WAN connection is IPv6 while
LAN connection is IPv4.
Associated WAN Interface: Select a WAN connection from the drop-down list. Only the
connected WAN connections can be shown in the drop-down list.
Associated LAN Interface: Select a LAN connection from the drop-down list. Only the
connected LAN connections can be shown in the drop-down list.
AFTR: Enter the IPv6 address of the remote node.
Click Save/Apply to make the configuration take effect.
Note:
In this type, there should not have any IPv4 WAN connections. If there are IPv4 WAN connections,
the page will prompt you to delete all the IPv4 WAN connections.
4.4.16 IPSec
Choose “Advanced Setup”“IPSec”, you can Add/Remove or Enable/Disable the IPSec tunnel
connections on the screen as shown in Figure 4-64.
Figure 4-64
This section will guide you to configure a VPN tunnel between two TD-W8950Ns. The topology is
as follows.
57
To Next Page
Loading...
