TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide
Note:
The priority, max upstream/downstream rate and min upstream/downstream rate work on
allocation of surplus upload/download bandwidth. For rules with different priority, the surplus
bandwidth is firstly allocated to the rule with the highest priority according to its max
upstream/downstream rate. If there still has surplus bandwidth, it is allocated to the rule with
hypo-high priority. For rules with the same priority, the surplus bandwidth is allocated to them
according to their min upstream/downstream rate. The greater a rule’s min upstream/downstream
rate is, the more bandwidth it gets.
4.4.10 Routing
Choose “Advanced Setup”“Routing”, it includes three menus: Default Gateway, Static Route
and RIP. The detailed descriptions are provided below.
4.4.10.1 Default Gateway
Choose “Advanced Set
up”“Routing”“Default Gateway”, you can see the Default Gateway
screen.
Figure 4-49
4.4.10.2 Static Route
Choose “Ad
vanced Setup”“Routing”“Static Route”. You can see the Static Route screen,
this screen allows you to configure the static routes (shown in Figure 4-50). A static route is a
pre-
determined path that network information must travel to reach a specific host or network.
48
To Next Page