TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-47
Rule Status: Select the status of the rule from the drop-down list to enable or disable the rule.
IP Range: Enter a single IP address or a range of IP addresses.
Port Range: Enter a single port or a range of ports.
Protocol: Select a protocol type from the drop-down list. TCP, UDP and ALL are available
here.
Priority: Select priority form the drop-down list. There are five options: Highest, 1, 2, 3, 4, 5, 6
and Lowest. The default precedence of the rule is 4.
Upstream: Enter the min and max upload speed through the WAN port.
Downstream: Enter the min and max download speed through the WAN port.
After completing the above configuration, click the Save/Apply button to make it take effect and
then you will see the following list as shown in Figure 4-48. If you want to modify the rule, click the
Edit button. If you want to delete the rule, check
the Remove box first and then click the Remove
button.
Figure 4-48
47
To Next Page
Loading...
