TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-50
To add static routing entries:
1. Click the Add button in Figure 4-50, and you will see the screen as shown in Figure 4-51.
Figure 4-51
2. Enter the following data:
IP Version: Select the version of IP.
Destination IP Address/prefix length: The Destination IP Address is the address of the
network or host that you want to assign to a static route.
Interface: Select the Interface name in the text box, or else, the default Use Interface will be
adopted for the Static Route.
Gateway IP Address: If you select the IPoE or IPoA mode for Interface, the screen above
will display this item, you should type the Gateway address correctly, and the other option for
Interface will adopt the default Gateway address for the Static Route.
3. Click Save/Apply to and then you will see you settings as shown in Figure 4-50.
To remove a static rout
ing entry:
1. Select the Remove check box according to the entry in the Figure 4-50.
2. Click the Remove button, and the entry will be deleted.
Note:
Gateway IP address should be correctly configured if IP based Interface (IPoE, IPoA) is selected.
49
To Next Page
Loading...
