TP-Link TD-W8960N - Page 27

TD-W8960N 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
4.4.1.2 ETH Interface
Choose “Advanced Set
up”“Layer2 InterfaceETH Interface”, you can configure ETH WAN
interfaces on the screen below.
Figure 4-4

Note:
To make sure the ETH port available, you should first choose “Advanced Setup”“LAN Ports” to
enable the Virtual LAN Ports feature.
 Add: Click the Add button, and you can add a new interface in the next screen.
Figure 4-5
 ETH port: Select an ETH port to configure as the WAN port.
Click Save/Apply to save your settings and then you will see the screen similar to Figure 4-6.
Figure 4-6
 Remove: Select the check box in the table on the screen above and then click the Remove
button, the corresponding interface will be deleted in the table.

Note:
One ETH is allowed to configure as the layer 2 WAN Interface.
18