TD-W8960N 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
Off
No storage d
evice or printer is plugged into the USB port.
On
There is a device connected to this LAN port.
Flash
The modem router is sending or receiving data over this LAN
port.
(LAN1-4)
Off
There is no device connected to this LAN port.
Note:
1. If the ADSL LED is off, please check your Internet connection first. Refer to 2.3 Connecting
the Modem Router for more information about how to make Internet connection correctly. If
you have already made a right connection, please contact your ISP to make sure if your
Internet service is available now.
2. If the Internet LED is off, please check your ADSL LED first. If your ADSL LED is also off,
please refer to Note 1. If your ADSL LED is GREEN ON, please check your Internet
configuration. You may need to check this part of information with your ISP and make sure
everything have been input correctly. Refer to 4.2 Device Info
for more information.
1.3.2 The Back Panel
Figure 1-2
ADSL: Connect to the Modem Port of Splitter or to the telephone line.
LAN1, LAN2, LAN3, LAN4/WAN: Through these ports, you can connect the router to your PC
or the other Ethernet network devices. Enable EWAN function and you will be able to connect
to Cable/FTTH/VDSL/ADSL device.
USB: The USB port connects to a USB storage device or a USB printer.
WiFi: The switch for the WiFi function.
RESET: There are two ways to reset the router's factory defaults.
5
To Next Page
Loading...
