TD-W8960N 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
Gateway IP Address: If you select the IPoE or IPoA mode for Interface, the screen above
will display this item, you should type the Gateway address correctly, and the other option for
Interface will adopt the default Gateway address for the Static Route.
3. Click Save/Apply to and then you will see you settings as shown in Figure 4-52.
To remove a static rout
ing entry:
1. Select the Remove check box according to the entry in the Figure 4-52.
2. Click the Remove button, and the entry will be deleted.
Note:
Gateway IP address should be correctly configured if IP based Interface (IPoE, IPoA) is selected.
4.4.10.3 RIP
Choose “Ad
vanced Setup”“Routing”“RIP”, you can see the screen as shown in Figure 4-54.
Figure 4-54
Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).
4.4.11 DNS
When you select the connection type PPPoE, PPPoA or IPoA for WAN configuration, you will see
the DNS menu in the Web-based Utility (shown in Figure 4-55). It includes DNS Serv
er and
Dynamic DNS submenus.
47
To Next Page
Loading...
