TP-Link TD-W8960N - Page 35

TD-W8960N 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
4.4.2.3 ATM-EoA-Bridging
If you want t
o adopt the Bridge service and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select EoA option for DSL Link Type (see 4.4.1.1 ATM
Interface).
2. Click the Add button on the screen Figure 4-7. Select WAN Service Interface over ATM PVC
on the next screen (as shown Figure 4-8).
3. Select Bridging option for the WAN s
ervice type on the screen (as shown Figure 4-9), and
click Next button to contin
ue.
4. On the screen (as shown Figure 4-13) you will see the detailed settings you’ve made. Please
click the Apply/Save button to save these settings.
4.4.2.4 ATM-PPPoA
If your ISP p
rovides a PPPoA connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select PPPoA option for DSL Link Type (see
4.4.1.1 ATM
Interface).
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to PP
PoE,
(see section 4.4.2.1
ATM-EoA-PPPoE). The difference is that you don’t need to set the
PPPoE Service Name and Bridge PPPoE Frames Between WAN and Local Ports on the
screen of Figure 4-10.
4.4.2.5 ATM-IPoA
If your ISP p
rovides an IPoA connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface.
1. Add a new ATM interface and select IPoA option for DSL Link Type (see 4.4.1.1 ATM
Interface).
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to IP
oE
(see section 4.4.2.2
ATM-EoA-IPoE). The difference is that you have to manually set the
Static IP Address on the screen of Figure 4-15, and the Static IP Address for DNS Server on
the screen of Figure 4-18.

Note:
ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot configure
any other WAN service over the ETH Interface until the ATM Interface is deleted.
4.4.2.6 ETH-PPPoE
If your ISP provid
es a PPPoE connection and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of 4.4.1.2
ETH Interface.
2. Click the Add button on the screen Figure 4-7 and the following configuration is similar to
PPPoE
over ATM interface (see section 4.4.2.1
ATM-EoA-PPPoE).
26