TP-Link TD-W8960N - Page 62

TD-W8960N 300Mbps Wireless N USB ADSL2+ Modem Router User Guide
Choose “Ad
vanced Setup”“IP Tunnel”, it includes two menus: IPv6inIPV4 and IPv4inIPv6,
The detailed descriptions are provided below.
4.4.15.1 IPv6inIPv4
Choose “A
dvanced Setup”““IP Tunnel”“IPv6inIPv4”. You can see the 6in4 tunnel
configuration screen, this screen allows you to configure the static routes (shown in Figure 4-63).
Figure 4-63
Click the Add button in Figure 4-63, and you can configure the 6in4 tunn
el on the next screen as
shown in Figure 4-64.
Figure 4-64
 Mechanism: 6RD, this type is used in the situation that your WAN connection is IPv4 while
LAN connection is IPv6.
 Associated WAN Interface: Select a WAN connection from the drop-down list. Only the
connected WAN connections can be shown in the drop-down list.
 Associated LAN Interface: Select a LAN connection from the drop-down list. Only the
connected LAN connections can be shown in the drop-down list.
 IPv4 Mask Length: The length of the selected WAN connection’s IPv4 mask.
 6rd Prefix with Prefix Length: The length of the 6rd prefix.
 Border Relay IPv4 Address: The IPv4 address of the border relay router of 6RD tunnel.
Click Save/Apply to make the configuration take effect.
 Note:
In this type, there should not have any IPv6 WAN connections. If there are IPv6 WAN connections,
the page will prompt you to delete all the IPv6 WAN connections.
53