The setting figure will be shown as below:
Figure 2-9 Switch Setting
You can configure the switch’s Device Description, DHCP Setting, IP Address, Subnet Mask
and Default Gateway on this page. The login User Name and Password are required to
complete the configuration. By default, they are both admin.
When the switch IP Address is not in the same subnet with host IP Address, it can be
discovered by the utility, but you cannot login the utility management page. Therefore, it needs
to set the switch IP Address in the same subnet with host IP Address, which allows you to login
the utility management page and configure the switch.
Clicking Apply can only make the new configurations effective before the switch is rebooted. If
you want to keep the configurations effective even the switch is rebooted, please select the
checkbox behind Save Config.
2.5 Refresh
Click Refresh in Figure 2-7 to restart the switch discovering process.
10
To Next Page
Loading...
