TP-Link TL-SG2008 - Device Diagnostics

127
Syntax
spanning-tree guard tc
no spanning-tree guard tc
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the TC Protect of Spanning Tree for port 2:
TL-SG2008(config)# interface gigabitEthernet 1/0/2
TL-SG2008(config-if)# spanning-tree guard tc
spanning-tree mcheck
Description
The spanning-tree mcheck command is used to enable mcheck.
Syntax
spanning-tree mcheck
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable mcheck for port 1/0/2:
TL-SG2008(config)# interface gigabitEthernet 1/0/2
TL-SG2008(config-if)# spanning-tree mcheck
show spanning-tree active
Description
The show spanning-tree active command is used to display the active
information of spanning-tree.
Syntax
show spanning-tree active
Command Mode
Privileged EXEC Mode and Any Configuration Mode