TP-Link TL-SG2008 - Show Interface Status; Show Interface Counters

84
show interface status
Description
The show interface status command is used to display the connective-status
of an Ethernet port.
Syntax
show interface [ gigabitEthernet port ] status
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the connective-status of all ports:
TL-SG2008(config)# show interface status
Display the connective-status of port 1/0/1:
TL-SG2008(config)# show interface gigabitEthernet 1/0/1 status
show interface counters
Description
The show interface counters command is used to display the statistic
information of all ports or an Ethernet port.
Syntax
show interface [ gigabitEthernet port ] counters
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the statistic information of all Ethernet ports:
TL-SG2008(config)# show interface counters
Display the statistic information of port 2:
TL-SG2008(config)# show interface gigabitEthernet 1/0/2 counters