TP-Link TL-SG2008 - Show Interface Configuration; Show Storm-Control

86
show interface configuration
Description
The show interface configuration command is used to display the
configurations of all ports or an Ethernet port, including Port-status, Flow Control,
Negotiation Mode and Port-description.
Syntax
show interface [ gigabitEthernet port ] configuration
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the configurations of all Ethernet ports:
TL-SG2008(config)# show interface configuration
Display the configurations of port 1/0/2:
TL-SG2008(config)# show interface gigabitEthernet 1/0/2 configuration
show storm-control
Description
The show storm-control command is used to display the storm-control
information of Ethernet ports.
Syntax
show storm-control [ interface { gigabitEthernet port | range gigabitEthernet
port-list }]
Parameter
port —— The Ethernet port number.
port-list —— The list of Ethernet ports.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the storm-control information of port 4, 5, 6, and 7: