TP-Link TL-SG2008 - Network Diagnostics

128
Example
Display the active information of spanning-tree:
TL-SG2008(config)# show spanning-tree active
show spanning-tree bridge
Description
The show spanning-tree bridge command is used to display the bridge
parameters.
Syntax
show spanning-tree bridge [ forward-time | hello-time | hold-count | max-age |
max-hops | mode | priority | state ]
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the bridge parameters:
TL-SG2008(config)# show spanning-tree bridge
show spanning-tree interface
Description
The show spanning-tree interface command is used to display the
spanning-tree information of all ports or a specified port.
Syntax
show spanning-tree interface [ gigabitEthernet port ] [ edge | ext-cost |
int-cost | mode | p2p | priority | role | state | status ]
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the spanning-tree information of all ports:
TL-SG2008(config)# show spanning-tree interface
Display the spanning-tree information of port 1/0/2: