- 85 -
To add/modify a Bandwidth Control rule, follow the steps below.
Step 1: Click Add New… shown in Figure 4-77, you will see a new screen shown in Figure 4-78.
Step 2: Enter the information like the screen shown below.
Figure 4-78 Bandwidth Control Rule Settings
Enable - Enable or disable the rule.
IP Range - Interior PC address range. If both are blank (or 0.0.0.0), the domain is no
effective.
Port Range - The port range which the Interior PC access the outside PC. If all are blank
(or 0), the domain is no effective.
Protocol - Transport layer protocol, here there are All, TCP, UDP.
Egress Bandwidth - The max and the min upload speed which through the WAN port,
default number is 0.
Ingress Bandwidth - The max and the min download speed through the WAN port,
default number is 0.
Step 3: Click the Save button.
4.16 IP & MAC Binding
Figure 4-79 The IP & MAC Binding menu
There are two submenus under the IP & MAC Binding menu: Binding Setting and ARP List.
Click any of them, and you will be able to scan or configure the corresponding function. The
detailed explanations for each submenu are provided below.
To Next Page
Loading...
