- 19 -
Figure 3-14 Quick Setup - Finish
3.2.3 Repeater Mode
When you set the operation mode switch to Repeater, take the following steps:
1. Click Next, and then Wireless Repeater page will appear as shown in Figure 3-15.
Figure 3-15 Quick Setup - Wireless
Wireless Name of Root AP - The SSID of AP that you want to access.
MAC Address of Root AP - The MAC address of AP that you want to access.
Survey - Click this button, you can search the AP which runs in the environment.
Region - Select your region from the pull-down list. This field specifies the region where
the wireless function of the Router can be used. It may be illegal to use the wireless
function of the Router in a region other than one of those specified in this field. If your
country or region is not listed, please contact your local government agency for
assistance.
WDS Mode - This field determines which WDS Mode will be used. It is not necessary to
change the WDS Mode unless you notice network communication problems with root
To Next Page
Loading...
