Note:
1) The WPS LED on the AP will light green for five minutes if the device has been successfully
added to the network.
2) The WPS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the WPS.
4.5 Working Mode
Please select one you want. Click Save to save your choice, which is shown as Figure 4-7.
Figure 4-7 Wireless Working Mode Settings
Wireless Router - The wireless Router Mode. In this mode, the device enables multi-user to
share Internet via DSL/Cable Modem. The only wired port works as WAN.
Access Point - The wireless access point mode.
4.6 Network
Figure 4-8 the Network menu
There are three submenus under the Network menu (shown in Figure 4-8): WAN, MAC Clone
and LAN. Click any of them, and you will be able to configure the corresponding function.
To Next Page
Loading...
