- 4 -
Status Indication
Solid The device is working properly.
Blinking
Condition 1: System is booting.
Condition 2: The Ethernet Cable or USB Device is
connecting to the product.
Table 1-1 The LED Description
USB: Connects a USB storage device for sharing or connects a mobile device to charge.
WPS/Reset
Press this button to connect devices via the WPS (Wireless Protected Setup)
method. Press and hold for 5 seconds to restore the router to its factory default settings.
Refer to the FAQ section for instruction.
LAN/WAN: Functions as the LAN port in Access Point, Repeater and Client mode. Functions
as the WAN port in Standard Wireless Router mode.
LAN: Connects an Ethernet-enabled device to the local network.
Operation Mode Switch: Select your Internet mode.
To Next Page
Loading...
