- 243 -
Figure 8-73 Bandwidth Control Rule List
Description - This is the information about the rules such as address range.
Egress Bandwidth - This field displays the max and mix upload bandwidth through the WAN
port, the default is 0.
Ingress Bandwidth - This field displays the max and mix download bandwidth through the
WAN port, the default is 0.
Enable - This displays the status of the rule.
Modify - Click Modify to edit the rule. Click Delete to delete the rule.
To add/modify a Bandwidth Control rule, follow the steps below.
Step 1: Click Add New… shown in Figure 8-73, you will see a new screen shown in Figure 8-74.
Step 2: Enter the information like the screen shown below.
Figure 8-74 Bandwidth Control Rule Settings
Enable - Enable or disable the rule.
IP Range - Interior PC address range. If both are blank (or 0.0.0.0), the domain is no
effective.
Port Range - The port range which the Interior PC access the outside PC. If all are blank
(or 0), the domain is no effective.
Protocol - Transport layer protocol, here there are All, TCP, UDP.
To Next Page
Loading...
