23
Source Setup
(Example: Integrating a
DVD 1210 R
)
Notes on wiring and assigning sources:
• Connect the analogue stereo output of the DVD
player directly to the pre-amplifier input
AUX 1
.
• Connect the picture signal to the decoder’s
DVD
socket using a SCART lead.
• Connect the sound signal to the decoder’s digital
input
DIG 1
using a digital lead.
• Complete the
R
LINK
connections.
• Move the switch marked
R
LINK
ADDR
on the back
panel of the DVD player to the
AUX
position.
• Make the following settings in the
'
Source Setup
'
:
1st column:
Enter the name by which the source
device is to be displayed on the de-
coder’s screen when you select it;
select
DVD
.
2nd column:
The picture signal from the DVD
player is passed to the decoder via
the
DVD
-SCART socket; set
DVD
.
3rd column
: The sound signal from the DVD
player is passed to the decoder via
the digital input
DIG 1;
set
DIG 1
.
4th column:
Assign the source button
AUX 1
to
the DVD player. This means that you
can select the machine in surround
mode by pressing the source button
9
99
9
or
d
dd
d
on the remote
control handset.
When you have completed the assigning process in
the '
Source Setup
' as outlined above, the system
works as follows in normal daily usage:
• In
stereo mode
pressing the source button
9
99
9
or
d
dd
d
selects the DVD player as current
stereo
source device
for playing CDs.
• A brief press on the
button on the remote
control handset, or the
.
..
.
button on the de-
coder, switches the system to
surround mode
. The
decoder input
DVD
becomes the current
listening
and viewing source for surround mode
. You can
now play a DVD in surround mode.
Source selection
- If you repeatedly press the
button on the
remote control handset (or the
2
22
2
button on
the front panel), you can select all the decoder’s
inputs in turn. In each case the name of the
source device is displayed on the screen.
- Pressing the remote control source button
9
99
9
or
d
dd
d
selects the DVD player directly, and
the source device name
'DVD'
appears on the
screen.
• If you wish to switch the system back to stereo mode,
briefly press the
)
))
)
button on the remote control
handset, or hold the
.
..
.
button on the decoder
pressed in for about one second.
To Next Page
Loading...
