37
CD player or CD mechanism:
Connect the components as shown in wiring diagram
4
as follows:
• Connect the digital sound output of the CD mecha-
nism to the digital input (
DIGITAL INPUT 2
) of the
decoder using a co-axial digital lead.
• Connect the
R
LINK
socket on the CD player to the
R
LINK
socket on the decoder; if this is already in use
by another source device, connect it to the vacant
R
LINK
socket on the second source device.
• If you also wish to use the CD player as a high-quality
analogue stereo source, connect its analogue output
to a vacant input on the pre-amplifier and assign the
source in the
'
Source Setup
'
.
• Finally connect the mains power supply and switch
the system on.
Note:
The purpose of connecting a CD player or CD mecha-
nism to the digital surround decoder is to play surround-
encoded CDs, or to exploit the artificial sound fields
available in the decoder. CDs encoded with Dolby Sur-
round and dts are available commercially.
Wiring diagram 4
A CD mechanism connected to the
DD 1230 R
.
A CD mechanism connected to the
DD 1530 R
.
To Next Page
Loading...
