32
When you have entered the correct settings in your TV
set, the next step is to check the connection between TV
set and decoder. This is done by calling up the
'
Device
Setup
'
on the decoder:
Press and hold the
button on the decoder.
• The menu should now appear on the screen. If it
does, close it by pressing the
button again
briefly.
• If the menu does not appear, or if the picture is
monochrome or unstable, read the
'
Trouble-
shooting
'
section in these operating instructions.
Use of banana plugs: see the section entitled
'
Back panel connections
'
.
Wiring diagram 1
Connecting the digital surround decoder to a TV set and the surround loudspeakers
DD 1230 R
.
To Next Page
Loading...
