T+A DD 1230 R - Connecting a SAT Receiver (Analogue Sound and Picture Source)

38
Digital SAT receiver (set-top box)
Connect the components as shown in wiring diagram
5
as follows:
• If the set-top box features an optical Dolby Digital
sound output, connect this to the digital input
(
DIGITAL INPUT 4
) of the decoder using an optical
cable.
Note:
If your set-top box features a co-axial digital output, it
can be connected to one of the digital inputs
1 . . . 3
.
• Connect the
SCART
socket on the set-top box to the
SETTOPBOX
socket on the decoder using a
SCART
lead.
Note:
Any other video source device with digital sound can
also be connected to the SETTOPBOX input instead
of a set-top box.
If your set-top box does not feature a SCART socket,
use the VIDEO (Cinch) or S-VIDEO (Hosiden) and
AUDIO (Cinch) sockets on the decoder and the set-
top box.
• If you also wish to use the AV device as a high-quality
stereo source, connect its analogue output to a va-
cant input on the pre-amplifier and assign the source
in the
'
Source Setup
'.
• Finally connect the mains power supply and switch
the system on.
Wiring diagram 5
A set-top box (digital sound and picture source) connected to the
DD 1230 R
.
A set-top box (digital sound and picture source) connected to the
DD 1530 R
.