T+A DD 1230 R - Connecting to T+A Integrated Amplifier; TASI and RLINK Interface Wiring

34
Connecting the decoder to a



integrated amplifier
with TASI and R
LINK
socket:
To keep the wiring diagram as clear as possible, only the
integrated amplifier is shown, i.e. not the analogue
source devices. The source devices should be con-
nected as shown in wiring diagrams
6
. .
11
. Complete
the wiring of the components as shown in wiring diagram
2 as follows:
• Connect the
TASI
interface on the decoder to the
TASI
socket on the

pre-amplifier or integrated
amplifier using the
TASI
lead.
• Connect the
R
LINK
socket on the decoder to the
R
LINK
socket on the integrated amplifier.
• If your system includes an active subwoofer, connect
the pre-amplifier output
PRE
to the subwoofer input
SUB IN
on the decoder.
Note:
If you are using a pre-amplifier with only one
PRE
output, and you have already connected the power
amplifier to this, you can use a
Cinch Y-lead
adaptor
to gain access to the pre-amplifier signal. Please ask
your specialist

dealer for advice.
• Finally connect the mains power supply and switch
the system on.
Wiring diagram 2
Connecting the
DD 1230 R
to a

integrated amplifier with TASI and
R
LINK
sockets.