$33(1',;%27+(5352'8&76)52075$&(
(1*,1((5,1*
&RS\ULJKW7UDFH(QJLQHHULQJ&R,QF 7HOHSKRQH 3DUW1XPEHU
WK
6WUHHW1( )D[ 2FWREHU
$UOLQJWRQ:$86$ ZZZWUDFHHQJLQHHULQJFRP 3DJH
$SSHQGL[%2WKHU3URGXFWVIURP7UDFH
(QJLQHHULQJ
6:6(5,(66,1(:$9(,19(57(5
A high power sinewave inverter/charger, the SW Series features low current distortion charger,
temperature compensation, series operation, fast transfer time, line tie capability, generator support,
generator start and user controlled auxiliary relays.
&08/7,385326(&21752//(5
The C40 is a 40-amp solar charge controller, DC load controller, or DC diversion regulator. The unit
works with 12, 24, or 48 volts systems and is rated at 40-amp continuous capacity. Other features of
the C40 are field adjustable setpoints, temperature compensation and protection, electronic overload
protection with manual or auto-reset ability, optional LCD meter, and an optional temp compensation
sensor.
&&+$5*(&21752//(5
The C-12 is a12 amp 3 stage solar charge controller, DC load, and automatic lighting control center.
The C12 is fully protected against overload, short-circuit, and reverse polarity. It is ideal for
controlling lighting systems as it uses a PV array as an electric eye to “see” when it is dark, so it
knows when to turn on the lights! Automatic reset, battery over discharge and overcharge protection,
two-stage lightning protection and surge suppression, and optional temp compensation sensor are a
few of the features of the C12.
6:$1''56(5,(632:(53$1(/6<67(06
Pre-assembled complete power panels featuring the SW or DR series inverters are now available.
Each panel is complete and complies with all codes (it is ETL listed). All you do is connect to the
battery and hook up AC loads. An AC system bypass allows AC loads to operate while the inverter
is locked out for servicing.
70%$77(5<67$786021,725
The Trace TM500 battery status monitor features seven data-monitoring functions and two alarms
that monitor battery state of charge, real-time amps, total charging amps, total load amps, days since
fully charged, cumulative amp-hours, recharge alarm and full charge indicator. Mounts up to 50 feet
from the batteries. Easily configured for liquid lead-acid or gel cell batteries. Works with 12, 24, or
48-volt systems.
Contact your Trace Engineering dealer for details on any of the above products.
To Next Page
Loading...
Need help?
General
