34
FLY TO
Fly To can direct you to your job, or other marker location such as an aireld
or loader. You can also set in latitude and longitude coordinates to y to.
The TML-A will give you the distance to your destination and an
approximate travel time.
To set up a Fly To, tap the “Fly To” icon on the left of the TML-A screen then
follow the instructions below.
Setting Fly To
1. Select where to
y to i.e. Markers,
or Current Blocks
(only if in an
active job)
2. Tap on the block or marker to y to OR Enter the Latitude and Longitude to y to
3. Click to start
Once started, an ETA
will be shown
To Next Page
Loading...