Need help?Do you have a question about the TracMap TML-A and is the answer not in the manual?
Details on connecting TML-A to VL.34, lightbar, CAN, USB, and GPS antenna.
Visual identification of essential parts like TMW cables, VL34, and LB16 lightbar.
Guide to logging in for the first time and creating new user profiles.
Steps for creating additional user profiles on the device for different users.
How to switch between different user profiles configured on the TML-A.
Steps to rename an existing user profile on the TML-A device.
Process for creating new presets and duplicating existing ones.
How to rename an existing preset configuration on the TML-A.
Steps to remove or delete unwanted preset configurations from the TML-A.
Accesses device configurations like display, map, GPS, and language.
Adjusts screen brightness, auto-brightness, and night mode.
Enables map display and selects map types like Satellite or Terrain.
Allows selection of GPS indicator icons for the aircraft.
Configures language, time zone, units, and speed units.
Settings for swath width, boom sections, and bucket spread.
Sets default guidance pattern and mode for new jobs.
Modifies swath width and overlap requirements for guidance.
Configures ABC line placement and pattern fitting.
Sets default lightbar and hazard warning configurations.
Adjusts timing, latency, and guidance light display modes.
Configures first/last light distance and spacing for guidance.
Selects data panels to display on the lightbar.
Configures supported controllers and their timing parameters.
Assigns flight stick buttons to TML-A actions.
Navigates menus and guidance lines using specific buttons.
Configures zoom and guidance line switching via hardware buttons.
Initiates and manages software updates for the device.
Displays device details and configures logging/debug settings.
Instructions for starting a job previously created online.
Steps to create and start a new job directly on the TML-A.
Process for adding geographical blocks to an existing job.
Details on how to add additional blocks to an ongoing job.
How to pause or finish a job and its implications.
Modifying job information such as products, notes, or customer.
Guide to transferring maps and jobs from a USB stick.
Steps to select and import a map file from a USB.
How to add a map to a job that is already in progress.
Options for exporting completed or partial jobs to USB.
How to choose and configure guidance patterns for jobs.
Visual examples of Back to Back and ABC guidance patterns.
Visual examples of Squeeze and Boundary guidance patterns.
Adjusting Auto-Boom settings for work style.
How swath settings affect boom activation and deactivation.
Configuring offline limit and minimum speed for automatic boom cutoff.
Setting up shortcuts to activate boom sections using input wiring.
Explains permanent and job marker categories and their uses.
How to rename or remove existing markers on the map.
Process for marking hazard locations on the map.
Steps for plotting wire locations, which appear as red lines.
How to place named markers within an active job.
Editing marker names or deleting them from the map.
How to set destinations for navigation to points of interest.
Using waypoints to map flight paths and calculate times/distances.
Overview of diagnostic icons and their meanings.
Troubleshooting connectivity and recognition issues for Hub, GPS, and USB.
To Next Page
General