Name: Trail Tech Vapor
Brand: Trail Tech
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Installation

Motorcycles, like ATV’s,

need a magnet placed on

the spinning part of the

wheel and the sensor

installed to a non-spinning

part.

The magnet typically gets

bolted or glued to the

brake rotor.

The sensor wire should

come from the back of the

computer, be cable-tied to

the brake line as it travels

down the front forks, then

attached to the brake

caliper.

Motorcycle Sensor/Magnet Installation:

Vapor can tell how far and fast

it’s traveled by keeping track of

how many times the magnet

passes under the sensor switch.

Many Motorcycles and ATV’s

have special installation

procedures. Refer to the

provided installation insert for

specific instructions for your

machine or visit

www.TrailTech.net.

Magnet About to Pass Under Sensor

Optimum Magnet Rotation Path

Other manuals for Trail Tech Vapor

Questions and Answers:

Need help?

Do you have a question about the Trail Tech Vapor and is the answer not in the manual?

General