Troubleshooting
41
The screen melted!
Did gasoline, degreasers, or other chemical cleaners come in contact
with Vapor’s screen? Some chemicals can easily damage Vapor.
Why is the LCD Display slow, or even worse, black?!
Vapor may have been exposed to too much direct sunlight while not
riding or temperatures below 0°C. Try the reset button and get Vapor
back to a normal temperature.
The Backlight won’t stay lit!!!
Vapor needs to be connected to vehicle’s 12 volt system in order for
the backlight to be continuous on. Review installation procedure.
Vapor’s internal battery is dead!
To replace the battery, use a coin to unscrew the round panel on the
back of Vapor. Remove the old battery and install the new one. Make
sure the positive pole is facing up. Replace with common watch
battery CR2302.
Why aren’t the LED’s working?
Vapor needs to be connected to vehicle’s 12 volt system in order for
the LED’s to function.
The temeperature LED’s require an optional engine temperature
sensor to be installed correctly and must be set in Data Setting Mode
correctly. They default to 0, in effect turned off.
The shift points must be set correctly in Data Setting Mode to function
correctly. They default to 0, in effect turned off.
REMEMBER TO PAY ATTENTION
TO THE TRAIL WHILE RIDING.
To Next Page
Loading...
Need help?
General