Trane CH531 Installation Instructions

4 SO-SVN037A-EN
Table of Contents
General Information . . . . . . . . . . . . . . . . . . . . . . . 5
About This Manual . . . . . . . . . . . . . . . . . . . . . . 5
Unit Model Number . . . . . . . . . . . . . . . . . . . . . 5
Other Required Manuals . . . . . . . . . . . . . . . . . 5
Required Tools . . . . . . . . . . . . . . . . . . . . . . . . . 5
Field-Provided Material . . . . . . . . . . . . . . . . . . 6
Model Number Descriptions . . . . . . . . . . . . . . . . 7
Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Nameplate . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Symbio 800 AdaptiView Display Upgrade Kit
Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Running the IPC Bus . . . . . . . . . . . . . . . . . . 9
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Check the Configuration and Set-Points in the
DynaView Display . . . . . . . . . . . . . . . . . . . 11
Save the DynaView Configuration and Set-
Points . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Remove the Existing Control Panel Door . . . 12
Install New Control Panel Door and Symbio 800
Controller
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Choosing Display Arm Mounting Location . . 13
Alternative mounting location: . . . . . . . . . . 14
Mounting Display Arm . . . . . . . . . . . . . . . . . . 14
Adjusting the Tracer AdaptiView Display
Arm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Install Power Supplies and Hardware . . . . . 16
Install 1A2 Power Supply—CH530 If Not Already
Present . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Install 1A2 Power Supply - CH531 Prebuilt Pan-
els . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Install Quad Relay Output LLID—CH530 If Using
Chiller Control Sequence 1 . . . . . . . . . . . . 17
Install Communication Cable Between 1A1 and
1A2 Power Supplies . . . . . . . . . . . . . . . . . . 17
Connect Input Power Wiring to 1A2 Power Sup-
ply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Routing New Wire Into and Out of the Control
Panel Enclosure . . . . . . . . . . . . . . . . . . . . . 18
Wiring Connections to the Display and Symbio
800 Controller . . . . . . . . . . . . . . . . . . . . . . . 18
Solid State Oil Heater Relay Installation . . . 21
Mounting Location . . . . . . . . . . . . . . . . . . . 21
Installation . . . . . . . . . . . . . . . . . . . . . . . . . .22
Install Options . . . . . . . . . . . . . . . . . . . . . . . . .23
LON Option Installation . . . . . . . . . . . . . . . .23
Communication Option . . . . . . . . . . . . . . . .23
Communication Device Mounting . . . . . . . .24
Water Flow Measurement Options . . . . . . .25
Energy Meter Option Installation . . . . . . . . .26
Expansion Module Option . . . . . . . . . . . . . .27
Before Restoring System Power . . . . . . . . .28
Restoring System Power . . . . . . . . . . . . . . .28
Programming . . . . . . . . . . . . . . . . . . . . . . . . . . . .29
Programming the Symbio 800 AdaptiView . .29
Start-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .32
Wiring Diagrams . . . . . . . . . . . . . . . . . . . . . . . . .33

Trane CH531 Specifications

General

Brand	Trane
Model	CH531
Category	Industrial Equipment
Language	English