Getting Started
SO-SVN037A-EN 9
Notes:
• Bk Black wire
• R Red wire
Running the IPC Bus
There are several ways to string the IPC communication bus
on the chiller. The Symbio™ 800 AdaptiView display upgrade
kit includes a general wire kit that has several different types
of wires. An example of a wiring layout can be seen in the
below figure. Each application will vary depending on the
options. You may have extra cables, or may be short needed
cables. Extra cables can be ordered through your local Trane
Parts Center. Use the latest version of General Service Bulletin
- Tracer® CH530/CH531 Pluggable Connector System
(PART-SVB16*-EN) (Tracer CH530/CH531 Pluggable
Connector System) for identification of individual cables.
Nut Hex; 7/16-20 3 X28020003110
Door assembly 1 506898140100
(a) All part number information in this table is subject to change at any time.
Table 1. Basic bill of material for Symbio™ 800 control upgrade kit (continued)
Description Qty. Part Number
(a)
Mnemonic Part Number
(a)
Figure 2. Ethernet cable for Symbio 800 controller to
display connection
Figure 3. Wire harness extensions: M to F connectors
and F connector to stripped
Figure 4. Two-conductor power supply
communication cable
Figure 5. USB Type B service port cable
WARNING
Hazardous Voltage w/Capacitors!
Failure to disconnect power and discharge capacitors
before servicing could result in death or serious injury.
Disconnect all electric power, including remote
disconnects and discharge all motor start/run
capacitors before servicing. Follow proper lockout/
tagout procedures to ensure the power cannot be
inadvertently energized. For variable frequency drives
or other energy storing components provided by Trane
or others, refer to the appropriate manufacturer’s
literature for allowable waiting periods for discharge of
capacitors. Verify with a CAT III or IV voltmeter rated per
NFPA 70E that all capacitors have discharged.
WARNING
PPE for Arc/Flash Required!
Failure to wear appropriate PPE could result in death or
serious injury.
On this unit, if the handle shield is cracked the circuit
breaker could arc/flash when reset. To avoid being
injured, technicians MUST put on all necessary
Personal Protective Equipment (PPE), in accordance
with NFPA70E for arc/flash protection, PRIOR to
entering the starter panel cabinet.
To Next Page
Loading...
Need help?
General
