General Information
6 SO-SVN037A-EN
The RadioShack
®
part number for the proper cable is 26-
117B.
• Type A to Type B USB cable to connect the Symbio 800
controller to a PC or laptop computer.
• A PC or laptop computer equipped with the following:
– TechView™ service software, version 12.1 or newer.
– Tracer TU service software, version 2.02 or newer.
– Rover™ service software (only required if the chiller is
equipped with a LonTalk
®
Comm5 board).
• South pole magnet screwdriver (TOL01343).
• Electronics vacuum.
Field-Provided Material
Some field provided material will be required to perform the
display retrofit. A list of material is provided here to help the
technician to plan ahead and to avoid material shortages at the
job site.
• Wire, red and green #16 AWG control wire - required to
make the connections between the power supply and
existing transformer.
• Wire connectors.
• Wire wrap or some other form of wire protection for areas
that wiring runs may come into contact with sharp edges.
• Cable ties to help “clean up” wiring runs.
If the unit is located outside, a cover is required for the display.
The Trane
®
part number for this cover is COV03916.
To Next Page
Loading...
Need help?
General
