RT-SVP04F-EN 69
System Programming SETUP
FIRE
Supply Fan - Off
Inlet Vanes - Closed (if equipped)
Return Fan/Exhaust Damper - Off/Closed (if equipped)
Return Fan VFD - Min
OA Dampers - Closed
Heat - All heat stages Off (staged gas and elec.), Hydronic heat & Mod Gas Heat output
at 0%.
Occupied/Unoccupied output - De-energized
VO Relay - Energized (with VOM module installed)
VCM Preheater State - Off (with VCM installed)
Ventilation Override Definitions Used with: All Units when VOM is
installed
Press ENTER to Review or Adjust
1. Pressing the NEXT key will bypass this section.
2. If the factory preset VOM modes (A, B, C, D, E) need to be
modified to meet specific application requirements, press the
ENTER key to advance to the following screens
Ventilation Override Definition Mode A Used With: All Units when VOM is
installed
Factory Presets: Refer to
Definitions
Possible Values: On, OFF
Supply Fan ON
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Ventilation Override Definition Mode A Used With: All Units when IGV or
VFD is installed
Factory Presets: Refer to
Definitions
Possible Values: IN CONTROL,
MIN, or MAX
Supply Fan IGV/VFD MIN
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Ventilation Override Definition Mode A Used With: All Units when VOM and
Power Exhaust with Statitrac is
installed
Factory Presets: Refer to
Definitions
Possible Values: On/OPEN, OFF/
CLOSED
Exhaust Fan/Dampers ON/OPEN
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
To Next Page
Loading...
