1Introduction
1.1 Purpose of the Quick Guide
The Quick guide provides information for safe installation
and commissioning of the frequency converter.
The Quick guide is intended for use by
qualied
personnel.
Read and follow the Quick guide to use the frequency
converter safely and professionally, and pay particular
attention to the safety instructions and general warnings.
Keep this operating guide available with the frequency
converter at all times.
1.2 Additional Resources
Trane Drive Utility (TDU) support
Download the software from www.trane.com/vfd.
During the installation process of the software, enter CD
key 52314600. A license key is not required for basic
operation. For advanced features enter license key
11131111.
The latest software does not always contain the latest
updates for frequency converters. Contact the local sales
oce for the latest frequency converter updates (in the
form of *.upd les), or download the frequency converter
updates from www.tranedrives.com.
1.3 Document and Software Version
The manual is regularly reviewed and updated. All
suggestions for improvement are welcome.
Edition Remarks Software
version
BAS-SVX58D-
EN
Update due to new SW & HW
version.
4.2
Software version 4.0x and higher introduced variable speed
cooling fans for longer life and reduced fan noise under
many operating conditions. Introduction of this feature
required new control cards that are not compatible with
older versions of software. Refer to Table 1.1 for hardware/
software compatibility.
Frame Size Approximate
date of
production
conversion
Old version New version
H1, H2, H3,
H4, H5
Week 26, 2018
Must use
software
version 3.xx or
below
Must use
software
version 4.xx or
higher
H6, H7, H8,
H9, H10
Week 37, 2018
Table 1.1 Hardware and Software Compatibility
1.4 Certicates and Approvals
Certication IP20
EC Declaration of Conformity
✓
UL Listed
✓
RCM
✓
AHRI
✓
Table 1.2 Certicates and Approvals
The frequency converter complies with UL 508C thermal
memory retention requirements. For more information,
refer to the section Motor Thermal Protection in the
product-specic
design guide.
1.5 Disposal
Equipment containing electrical components
must not be disposed of together with domestic
waste.
It must be separately collected with electrical
and electronic waste according to local and
currently valid legislation.
Introduction TR150 and TR170 Quick Guide
BAS-SVX58D-EN
08/2020 All rights reserved.
3
1 1