RT-SVX34C-EN 41
Installation Electrical
Remote Panels and Sensors
Constant Volume Control Options
The RTRM must have a zone sensor or conventional thermostat to operate the rooftop unit. If using
a zone sensor, mode capability depends upon the type of sensor and/or remote panel selected to
interface with the RTRM. The possibilities are: Fan selection ON or AUTO, System selection HEAT,
COOL, AUTO, and OFF. Refer to Figure 21 on page 41 for conventional thermostat connections.
The following Constant Volume controls are available from the factory for field installation.
WARNING
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.
Zone Panel (BAYSENS106*)
This electronic sensor features three system switch settings (Heat, Cool, and Off) and two fan
settings (On and Auto). It is a manual changeover control with single setpoint capability.
Figure 21. RTRM Zone Sensor/Thermostat Connections
ZSM INPUTS
CV/VAV
(CV ONLY)
ZSM INPUTS
INPUTS
To Next Page
Loading...
