Trek Speed Concept 2014 - SRAM GXP Crankset Installation

39 TREK SERVICE INFORMATION August 2016
SRAM GXP
These instructions explain how to install a SRAM/TruVativ/Bontrager GXP crankset (Figure
1) in a new Speed Concept. To complete the installation, you will also need the SRAM
instructions, available at: http://www.sram.com/_media/techdocs/2005_gxp-05-r5-e.pdf
Tools And Materials Required
• Crankset and bottom bracket
• 8 mm hex wrench
• Bearing installation tool PN 404694
• Rock “N” Roll Super Coat grease
• Bottom bracket parts
• TruVativ GXP installation instructions
Figure 14.6. SRAM bearing set
Seal
Bearing
Metal seal
Bearing with lip (facing in)
Wave washer
Part Descripon SRAM
Kit 404700
Ceramic kit 411814