Trek Speed Concept 2014 - Using A Repair Stand; To Attach The Workstand Clamp Adapter

6 TREK SERVICE INFORMATION August 2016
5. Using A Repair Stand
This section explains how to correctly put the Speed Concept in a work stand.
Do not clamp the frame. The only accepted or recommended method for holding the Speed
Concept is to use the special workstand clamp adapter designed specifically to clamp the
seatpost (Figure 5.1). The adapter clamps only to the seatpost, which must be installed first.
Figure 5.1. Madone clamp adapter
Tools and materials required
• Workstand
• Workstand clamp adapter,
PN 403494
• Adapters, PN 416101
To Aach The Workstand Clamp Adapter
1. Open the clamp adapter (Figure 5.1).
2. Insert the elliptical adapters (Figure 5.2).
3. Wrap the adapter around the seatpost.
If needed, raise the seatpost to provide room for the adapter to clamp.
4. Insert the base of the clamp adapter into the workstand.
Figure 5.2. Ellipcal seatpost adapters for Madone clamp