TREND MT/JIG - Fitting the Optional Dust Extraction Kit

MT/JIG
Fitting the
Optional Dust
Extraction Kit.
Ref. MT/DUSTKIT
10mm


 Fit the dust spout
using the 4 bolts,
shake-proof
washers and
nuts.
 Assemble the
ring, fitting and
body of the
adaptor onto
the 39mm hose if
required.
 Fit the two
magnets by
gently knocking
them into the
front edge on the
underside of the
top plate with a
wooden mallet
until flush.
 The optional dust
shield should only
be fitted when
cutting 90°
tenons. It is
held in place by
magnets.
-11-




x2
MANU-M&Tv2.2 8/7/10 10:51 Page 11