TREND MT/JIG - Front Angled Tenon

MT/JIG
-18-
Front Angled
Tenon
or
When angle is
greater than 20°
move top F clamp
to its lower position.







Remove the two
side bolts. Adjust
the tilting back
plate to the
position required.
 Tighten the two
side bolts with the
hex key.
 Rout the end of
the timber parallel
to the top plate or
cut at the
appropriate angle
on a snip-off saw.
 Fit and clamp the
timber at the
correct height
using the set-up
bar. (See p.13)
Set the templates
to the required
tenon length.
(See p.14)
Set the top plate
to the centre line.
(See p.15)
 Set the depth of
cut and rout in
increasing depths
to complete the
tenon.
MANU-M&Tv2.2 8/7/10 10:51 Page 18