TREND T10 User Manual

T10 & T11
-8-
ASSEMBLY & ADJUSTMENT
I Set the measuring lens (5) to a round figure
or zero.
I Adjust the depth of cut using the knob (6) and
the measuring lens (5).
The distance between the top of the revolving
depth stop and the bottom of the depth stop is
the required depth of cut.
I Tighten the knob (2).
The rotating turret stop screws can be used
for pre-setting up to three depths of cut.
Their
height can be adjusted using a screwdriver
(7) and an 8mm A/F spanner (8).
1
7
3
8
By turning the turret stop, three depth settings
can be quickly made.
4
5
4
2
3
1
6
I Never make adjustments
when the router is running or
plugged in.
I Deep cuts should always be
routed in several passes.
If the depth of cut needs re-adjustment, it is
recommended to use the depth stop micro
adjuster.
I Adjust the depth of cut using the depth stop
micro adjuster (3). One turn corresponds to
approximately 1mm.
I Read the depth of cut using the measuring
lens (5) and scale.
I Adjust the depth of cut to the millimetre using
the knob (6).
ON
OFF
I
O
O
N
O
F
F
I
O
Switching On & Off
I On; pull the switch up.
I Off; press the switch down.
Adjusting the Depth of Cut
I Place the machine with cutter fitted on to the
workpiece.
I Pre-set the 3-way turret stop (1) as required.
I Undo the thumb knob (2) for securing the depth
stop (3).
I Lift up the plunge locking lever (4) for fixing the
depth.
I Lower the machine slowly until the cutter
touches the workpiece and secure it with the
locking lever.
I
Rotate the knob (6) until the depth stop micro
adjuster (3) touches the revolving depth stop (1).
MANU-T10 v2.0 2/2/05 2:31 pm Page 8
B&D_47

TREND T10 Specifications

General

Brand	TREND
Model	T10
Category	Network Router
Language	English