T10 & T11
-22-
MAINTENANCE AND CARE
Cleaning
I Keep the machine clean at all times. Some
maintenance products and solvents may
damage the plastic parts, these include
products containing Benzene, Trichloroethyle
Chloride and Ammonia.
I Never use any caustic agents to clean the
plastic parts.
Changing Brushes
I Undo the two screws and take off the top
cover.
I Undo the two screws and move variable
speed control out of the way.
I Undo the screws holding the brush holder
clamp and remove holder with brush.
I Remove leads, pull on brush tab and remove
brush.
I Fit new brush into holder.
I Refit lead and replace brush assembly into
the housing.
I Replace brush holder cover and screws.
I Refit speed control to position and secure
with screws.
I Replace cover and secure with screws.
I Always use original T10/T11 spare parts.
Lubrication
I The bearings of the machine need no
lubrication, as they are sealed. The two
plunge columns on the routing base should
be slightly oiled from time to time.
I Keep the cooling vents on the motor housing
clean and unobstructed at all times. Blow out
any dust and dirt at regular intervals.
I Visually check the carbon brushes. In the
event of excessive sparking, they may need
changing.
I After about 40 operating hours inspection by
a authorised Trend service agent is
recommended.
RECYCLING
Machine, accessories and packaging should be
sorted for environmentally friendly recycling.
Unwanted tools should be taken to your nearest
Trend Service Agent where it will be disposed of
in an environmentally safe way.
GUARANTEE
The machine carries a manufacturers guarantee
in accordance with the conditions on the
enclosed guarantee card.
For the location of your nearest Trend Service
Agent, please call the telephone number at the
back of this manual.
The carbon brushes will need replacing when
they become worn to a certain limit.
Ensure machine is isolated
from power supply.
It is advisable to have the brushes
replaced by an authorised Trend
service agent. The router will also be
given a thorough inspection.
To Next Page
Loading...
Need help?
General
